Tuesday, June 4, 2013
Oil change Auto Mazda
Oils, which are used in manual transmissions, it is absolutely not suitable for transmission with automatic transmission, then were invented a special type of oil (ATF). Maintenance for Automatic Vehicle Mazda (Mazda) have to do anyway, even if the instruction manual says nothing about replacing the transmission fluid. There are signs by which you can see that understated the level of fluid in the automatic transmission Mazda (Mazda): a deep and prolonged shifting, noise during the automatic transmission, unless there is a move in the moment of switching gears. Fluid must be replaced about every 50-70 thousand miles. And if the car is Mazda (Mazda) is operated in a rather harsh conditions (eg, taxis, private tow, travel to rural or mountainous terrain) - is already changing in 25-30 thousand km. If the transmission is "automatic", it only applies specially designed for her oil ATF (Automatic Transmission Fluid). If you look at the form, then it is red and almost odorless. Use a different oil is not recommended, only if so recommended by the manufacturer. Replace automatic transmission fluid in two ways: 1.Sdelat partial replacement fluid. First, remove the pan Auto, then the filter and gasket, and replace oil leaked out of the box (it will be approximately 35-45% of the total oil). Happens that way because most oil is in a great number of channels automatic transmission and torque converter. After these procedures, new and old oil blend. 2.Sdelat complete replacement fluid. That is to fully replace fluids requires special equipment. Connects it to the oil system and automatic transmission makes it possible to replace the old fluid with new. This procedure is carried out in three stages: first rinsed system designed for automatic transmission of this liquid, then there is a replacement of old oil for new and final stage - is to replace the pan gasket and filter element. This approach to fluid replacement automatic transmission delivers 100% of replacement fluid. Since the oil change takes place under pressure, then the first pass liters of fluid are well washed Automatic system, leaving no way the old fluid sediments from the convector and metal chips.
No comments:
Post a Comment