Friday, April 12, 2013
BMW Z3 model 80. v2 installation instructions
Content:
1. at the bottom of the housing model 80
2. the model 80 vinyl-covered enclosure top
3. Alumapro Alusonic 8 subwoofer (optional)
4. Subwoofer Grille (optional)
5. the Terminal cup
6. the Self-adhesive gasket foam
7. cut the cord
8. (8) # 10 x 3/4 "Phillips pan screws
9. (4) # 10 x 1 "hex head sheet metal screws
10. (4) 1 "basket of tiles
11. (4) 3/8 "thick rubber washers
12. (12) 1/16 "thick rubber washers
13. (4) # 8 x ½ "Phillips head screws
14. (4) # 8 nuts
What you need:
1. Power drill
2. for 5/16 ", 3/16", 7/64 ", 1/8" drill bits
3. Philips screwdriver
4.3/8 "socket driver or wrench
5. Stiff Blade putty knife or similar flat-bladed tool
6. life management saw or hacksaw blade holder & blade
Remove the old enclosure
1. carefully remove the cover on the rear of the subwoofer enclosure lid lifting first, and then raising the size of the cover straight up. The cover should be removed, but it may require extra effort to release the rear. Take your time and be careful when removing the cover, sub-! The easiest way is to add a flat, metal, deals with the tool as a stiff putty knife and carefully pry up the back on each side.
2. remove the mounting screws (2) in the light of the current speaker enclosure (1) 4.
3. remove the old casing (1) by pulling upwards. Disconnect the wiring harness connector (2), and remove the entire casing of the vehicle.
4. using a socket wrench, loosen and remove the brackets (1) that the original plant was connected to the enclosure. The color of the diagonal cutters or a small knife, carefully cut away the plastic saw 4 (2).
Downloadhere
No comments:
Post a Comment